Real-time Service Area
for Minneapolis, MN
Our Top Cities
Nate H.
Customer called and scheduled an appointment because her pull release cord for the garage door opener had caught on the roof rack. When I got on site, I did observe it was sitting a little low, I ended up shortening the cord to prevent it from catching on the roof rack again. Customer drove her vehicle in before I left to make sure it was high enough and her vehicle did clear. Customer was happy with the work performed.
Dusty L.
Springs
Dusty L.
Springs
Dusty L.
Springs
Nate H.
Customer scheduled an appointment because her door was making excessive noise during operation. I was able to diagnose it as a dry door. The recommended action would be a garage door tuneup. Customer authorized getting a tuneup done. Once the tuneup was completed, the door had operated smoothly quietly and efficiently as it should.
Austin D.
Garage door repair
Nate H.
An appointment was set up with all American door because a single stall door was not opening. When I arrived on site, I was able to figure out the door did have a broken spring. There was slack in the cables. Recommendation and estimate was typed up for a spring replacement. Customer decided to move forward with it once the spring rolls replaced the door properly balanced, and ran flawlessly and operated with the opener as it should.
Austin D.
Garage door tuneup
Nate H.
Customer called for a repair versus replace. The spring was broken when I had arrived on site. I went over options for the customer. Did an inspection had an estimate typed up for part replacement versus a new door. Customer decided on moving forward with a new door, they did sell on site.
Nate H.
Customer scheduled an appointment because they had backed into the bottom section of the door. When I arrived on site, it was very clear that the section could not have a temporary repair done and needed to be replaced. I got all the necessary measurements and photos so a section replacement estimate could be sent over to the customer
Nate H.
Customer called because her door was not sealing up all the way and not sealing properly. When I arrived on site I was able to quickly diagnose that the PVC weatherstripping that mounts to the garage door. Opening was torn and recommended replacement. Customer authorize the trim replacement once all the work was completed. The door had sealed up properly and now the customer will not have a draft in the garage.
Nate H.
Customer was having garage door opener issue so he did schedule an appointment. When I got on site, I quickly diagnosed one opener to have a failing gear and limit switch. The other opener had a logic board failure as well. Did inspections of the doors noticed cables and bottom brackets were rusting out as well as noticed springs were dated from 98 which is well beyond the expected lifespan an estimate was typed up with all the recommended part replacements. Customer wanted an estimate sent over so he could talk it over with his family
Austin D.
Garage door spring replacement
Nate H.
Customer called out for a service because the door was sitting crooked, when I got out on site noticed they had two single stall doors on extension springs. During my inspection, I found that one of the extension springs and the cabling were removed from one of the doors which was causing the door to sit on level. These doors being that they are original to the house, the replacement was suggested not only due to the age, but due to the cost of what part replacements needed to be done, measurements were taken a new door estimate was typed up and sent over to the customer.
Nate H.
Garage door was having safety sensor issue. It was not closing properly. Quickly diagnose the issue as a sensor that had a loss of power did an inspection of the door and found cables and bottom fixtures were also rusting out recommended replacement of sensors and bottom brackets, as well as cables for the customer once Work was completed the door operated has it normally should