Real-time Service Area
for Mission Hills, KS
Our Top Cities
Lewis G.
Renew membership, clean 3 system blower wheels, install new humidifier, replace inducer motor.
Johann A.
Went for a maintenance call today for heat. Tested for static pressure system is passing when in heat. All electrical components are passing for manufacture specifications. Did a combustion test is within range. Inspected heat exchanger no cracks/leaks were detected. Checked temp split and is passing. Cleaned flame sensor and pressure switch hose. Did replace water panel on humidifier. System is up and running before departure. Thank you for choosing LBA services-Johann
Patrick K.
Arrived to do a performance maintenance. Started maintenance with the basement system. Set up for combustion analysis temperature split and static pressure tests. Verified operation of all mechanical and electronic components of the furnace. Checked blower for cleanliness and to see if there is any play in the bearings. Checked systems heat exchanger to ensure proper venting of flue gas. Performed an electronic gas leak search. Verified operation of the humidifier. Found that the humidifier panel is coated in calcium and is leaking. Moved inspection to the attic system. Verified temperature split. Checked inside the system for cleanliness. Found that the evaporator coil is impacted with debris and the blower wheel is coated in dust debris. Each of these will impede airflow. Verified operation of heat strips. Measured the systems static pressure. Furnace and air handler are operational at this time.
Tory P.
Capped line to basement bar sink, auger lav sink
Johann A.
Went for an outage today. When inspecting unit control board was cutting off power and causing for it to short cycle. Did jumper unit into cooling. Main floor unit charge is low. Upstairs unit is also low with contaminated refrigerant. Both heat exchanger do have rust and heat stress. Did show customer wear and tear in system. As well had a supervisor come out and will have solutions for customer. Thank you for choosing LBA services-Johann
Lane H.
Full system X2
Andrew S.
Arrived for ac out. Upon arrival I found the thermostat was blank. Tested power and found the stat had went out. Replaced stat and system started up. I cycled between ac and heat to make everything is starting and shutting down correctly. System is operating properly. Thanks for choosing LBA.
Johann A.
Insulation on unit was been resealed.
Johann A.
Wet switch was tripped. Rest system is now up and running. Before leaving thank you for choosing LBA services-Johann
Johann A.
A-1 Sewer & Septic Service performed the following services: - Jackhammered the floor in the concrete patio to get access to install a 30ft liner to the house for the kitchen line stack. - Performed a 100ft hole-to-hole burst from the left corner of the house to clean out past the covered patio. - Trench 30ft of sewer line past the patio to where the two lines exiting the home connected. - Installed two new cleanouts. One in the front yard and one by the back patio. - Bed new plumbing in gravel to prevent any settling. - Passed inspection through Johnson County Wastewater. - Backfilled all of the trenches, compacting the dirt to get the ground as flat as possible. - Poured back concrete to replace what was removed. - Gave homeowner options, through LBA, to replace the rest of the line. The customer opted to use the warranty company for additional spot repair. Spot Repair downstream from our repair was performed by another company, K-Jett. - Hauled off job-related spoils.
Patrick K.
Arrived to remedy a system that is freezing up. Checked the evaporator coil to ensure it is not coated in ice. Kicked system on and found it operating like normal. Checked the refrigerant levels and found them off. Performed diagnostic and found that the metering device for the refrigerant is in need of adjustment. Slowly made this adjustment, constantly checking refrigerant gages outside. Once metering device was calibrated properly made the necessary adjustments to the refrigerant levels. System is functioning properly at this time.
Andrew S.
Arrived to replace blower motor. Put in new motor and checked running amps. They are holding steady and not jumping up and down like before. There is a 20 degree temp split, which is great. System is running upon departure. Thanks for choosing LBA.
Lane H.
Blower motor.
JJ H.
AC is running great. Refrigerant pressures met factory specifications. Furnace blower motor is weak. Blower wheel is also dirty. Inducer motor is leaking. Heat exchanger has heat stress marks. Low airflow through the house with correct blower speeds and good duct work. Thank you for choosing LBA services!
Lane H.
Membership, follow up on blower and set follow up appointment to check heat exchanger.